| Sensing method | Diffuse reflective (mark detection) |
| NPN output | E3ZM-V61/-V66 |
| PNP output | E3ZM-V81/-V86 |
| Sensing distance | 12±2 mm *1 |
| Sensing range | Depends on the combination of colors. Refer to Engineering Data on page 7 for details. |
| Spot diameter | 2-mm dia. max. |
| Light source (wavelength) | White LED (450 to 700 nm) |
| Power supply voltage | 10 to 30 VDC, including 10% ripple (p-p) |
| Power consumption | 750 mW max. (current consumption for a 30-V power supply voltage: 25 mA max.) |
| Control output | Load power supply voltage: 30 VDC max., Load current: 100 mA max. (Residual voltage: 2 V max.) Open-collector output (NPN/PNP output depending on model) |
|
Remote control input | NPN output ON: Short-circuit to 0 V, or 1.5 V max. (source current: 1 mA max.) NPN output OFF: Open or Vcc -1.5 V to Vcc (leakage current: 0.1 mA max.) PNP output ON: Vcc -1.5 V to Vcc (sink current: 1 mA max.)
PNP output OFF: Open or 1.5 V max. (leakage current: 0.1 mA max.) |
| Operating modes | Set in the order of the teaching operation. *2 |
| Protection circuits | Reversed power supply polarity, Load short-circuit protection, and Reversed output polarity protection |
| Response time | Operate or reset: 50 ms max. |
| Sensitivity adjustment | Teaching method |
| Ambient illumination | (Receiver side) Incandescent lamp: 3,000 lx max., Sunlight: 10,000 lx max. |
| Ambient temperature range | Operating: -40 to 60°C (*3), Storage: -40 to 70°C (with no icing or condensation) |
| Ambient humidity range | Operating: 35% to 85%, Storage: 35% to 95% (with no condensation) |
| Insulation resistance | 20 MΩ min. (at 500 VDC) |
| Dielectric strength | 1,000 VAC at 50/60 Hz for 1 min |
| Vibration resistance (destruction) | 10 to 55 Hz, 1.5-mm double amplitude for 2 h each in X, Y, and Z directions |
| Shock resistance (destruction) | 500 m/s2 for 3 times each in X, Y, and Z directions |
| Degree of protection *4 | IEC 60529: IP67, DIN 40050-9: IP69K |
| Connection method | Pre-wired cable (standard length: 2 m) or M8 4-pin connector |
| Indicator | Operating indicator (yellow), Stability indicator (green), and Teaching indicator (red) |
| Weight (packed state) | Pre-wired models (2-m cable): Approx. 85 g Connector models: Approx. 35 g |
| Housing | SUS316L |
| Lens | PMMA (polymethylmethacrylate) |
| Indication | PES (polyethersulfone) |
| Buttons | Fluoro rubber |
| Cable | PVC (polyvinyl chloride) |
| Accessories | Instruction sheet Note: Mounting Brackets are purchased separately. |
